Keysight Technologies 8163A/B - Page 191

8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide 191
Measurement Operations & Settings 4
response: none
example: OUTP1:POW:OFFS:POW 4,4
affects: Attenuator modules with power control.
command: :OUTPutn[:CHANnel[m]]:POWer:CONTRol
syntax: :OUTPutn[:CHANnel[m]]:POWer:CONTRol<wsp>OFF(0) | ON(1)
description: Sets whether the power control mode is on or off.
If power control is enabled, the attenuator automatically compensates for changes to
input power.
parameters: OFF or 0
ON or 1
Output power follows changes to input power.
The filter position automatically adjusts to compensate for changes to input power, so maintaining the
output power set by the user.
response: none
example: OUTP1:POW:CONTR ON
affects: Attenuator modules with power control.
command: :OUTPutn[:CHANnel[m]]:POWer:CONTRol?
syntax: :OUTPutn[:CHANnel[m]]:POWer:CONTRol?
description: Queries whether the power control mode is on or off.
parameters: none
response: boolean 0 The power control mode is off
1 The power control mode is on.
example: OUTP1:POW:CONTR?
-> 0<END>
affects: Attenuator modules with power control.