8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide 35
Specific Commands 2
:SENSe[n][:CHANnel[m]]:CORRection
[:LOSS][:INPut][:MAGNitude]/? Sets or returns the value of correction data for a sensor. page 94
:COLLECT:ZERO Executes a zero calibration of a sensor module. page 94
:COLLECT:ZERO? Returns the current zero state of a sensor module. page 95
:COLLECT:ZERO:ALL Executes a zero calibration of all sensor modules. page 95
:SENSe[n][:CHANnel[m]]:FUNCtion
:PARameter:LOGGing/? Sets or returns the number of samples and the averaging time, t
avg
, for
logging.
page 97
:PARameter:MINMax/? Sets or returns the minmax mode and the window size. page 98
:PARameter:STABility/? Sets or returns the total time, delay time and the averaging time, t
avg
, for
stability.
page 99
:RESult? Returns the data array of the last function. page 100
:RESult:BLOCk? Returns a specified binary block from the data array for the last power meter
data acquisition function.
page 101
:RESult:MAXBlocksize? Returns the maximum block size for power meter data acquisition functions. page 102
:RESult:MONitor? For return loss module, returns monitor diode data array of last function. page 103
:STATe/? Enables/disables the function mode or returns whether the function mode is
enabled.
page 104
:THReshold/? Sets or returns the threshold value and the start mode. page 105
:SENSe[n][:CHANnel[m]]:POWer
:ATIMe/? Sets or returns the average time of a sensor. page 106
:RANGe[:UPPer]/? Sets or returns the most positive signal entry expected for a sensor. page 106
:RANGe:MONitor[:UPPer]/? Sets or returns the range of the monitor diode within a return loss module. page 108
:RANGe:AUTO/? Sets or returns the range of a sensor to produce the most dynamic range
without overloading.
page 109
:REFerence/? Sets or returns the reference level of a sensor. page 110
:UNIT/? Sets or returns the units used for absolute readings on a sensor. page 115
:WAVelength/? Sets or returns the wavelength for a sensor. page 115
Command Description Page
To Next Page
Loading...
