Keysight Technologies 8163A/B - Page 193

8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide 193
Measurement Operations & Settings 4
command: :OUTPutn[:CHANnel[m]]:POWer:UNit?
syntax: :OUTPutn[:CHANnel[m]]:POWer:UNit?
description: Queries whether the power unit is dBm or W
parameters: none
response: boolean 0 The power unit is dBm
1 The power unit is W.
example: OUTP1:POW:UN?
-> 0<END>
affects: All attenuator modules, and 81950A.
command: :OUTPutn[:CHANnel[m]]:[STATe]
syntax: :OUTPutn[:CHANnel[m]]:[STATe]<wsp>OFF(0) | ON(1)
description: Sets the state of the shutter.
parameters: OFF or 0
ON or 1
Shutter closed.
Shutter open.
response: none
example: OUTP1:STAT OFF
affects: All attenuator modules, and 81950A.
command: :OUTPutn[:CHANnel[m]]:[STATe]?
syntax: :OUTPutn[:CHANnel[m]]:[STATe]?
description: Queries the state of the shutter.
parameters: none
response: boolean 0 The shutter is closed.
1 The shutter is open.
example: OUTP1:STAT?
-> 0<END>
affects: All attenuator modules, and 81950A.
command: :OUTPutn[:CHANnel[m]]:STATe:APOWeron
syntax: :OUTPutn[:CHANnel[m]]:STATe:APOWeron<wsp>OFF(0) | ON(1)
description: Sets the state of the shutter when the mainframe is turned on.