Keysight Technologies 8163A/B - Page 171

8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide 171
Measurement Operations & Settings 4
command: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE
syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE<wsp><mode>
description: Sets the sweep mode.
Cannot be set while a sweep is running.
parameters: STEPped:
MANual:
CONTinuous:
Stepped sweep mode
Manual sweep mode
Continuous sweep mode
response: none
example: wav:swe:mode STEP
affects: All tunable laser modules except Keysight 81649A, Keysight 81689A/B, 819x9A, and 81950A.
command: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE?
syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE?
description: Returns the sweep mode.
parameters: none
response: STEP:
MAN:
CONT:
Stepped sweep mode
Manual sweep mode
Continuous sweep mode
example: wav:swe:mode? -> STEP<END>
affects: All tunable laser modules, except 81950A.
command: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:PMAX?
syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:PMAX?<wsp><start wavelength>,
<stop wavelength>
description: Returns the power to the highest permissible power for the selected wavelength sweep.
parameters: start wavelength:
stop wavelength:
The wavelength at which the sweep starts as a float value.
The wavelength at which the sweep starts as a float value.