180 8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
4 Measurement Operations & Settings
command: :SOURce<SlotNr>:TRANsmitter:RECalibration?
syntax: :SOURce<SlotNr>:TRANsmitter:RECalibration?
description: Recalibrates a reference transmitter module.
Recalibration takes about 6.8 seconds, so it also takes this time to get the reply to this query.
parameters: none
response: The result is returned as an unquoted string:
“OK” or “ERROR - <error message>”.
example: :SOUR1:TRAN:REC?
−> OK<END>
affects: 81490A
command: :SOURce<SlotNr>:TRANsmitter:OPOint<laser (1,2)>
syntax: :SOURce<SlotNr>:TRANsmitter:OPOint<laser (1,2)> <data>
description: Sets the operating point for one of the reference transmitter's two laser diodes.
You can also set the minimum, maximum or default value.
parameters: Operating point or MINimum | MAXimum | DEFault.
response: none
example: :sour1:tran:opo1 -17
affects: 81490A
command: :SOURce<SlotNr>:TRANsmitter:OPOint<laser (1,2)>?
syntax: :SOURce<SlotNr>:TRANsmitter:OPOint<laser (1,2)>?
description: Get the operating point for one of the reference transmitter's two laser diodes.
You can also query the minimum, maximum or default value.
parameters: none | MINimum | MAXimum | DEFault
response: The operating point.
example: :sour1:tran:opo2
−> -17<END>
affects: 81490A
To Next Page
Loading...
