8163A/B, 8164A/B & 8166A/B Mainframes
Programming Guide
3 Instrument Setup and
Status
IEEE-Common Commands / 46
Status Reporting – The STATus Subsystem / 55
Interface/Instrument Behaviour Settings – The SYSTem Subsystem
/ 68
This chapter gives descriptions of commands that you can use when
setting up your instrument. The commands are split into the following
separate subsytems:
• IEEE specific commands that were introduced in Common Commands on
page 20.
• STATus subsystem commands that relate to the status model.
• SYSTem subsystem commands that control the serial interface and
internal data.
To Next Page
Loading...
