Keysight Technologies 8163A/B - Page 74

74 8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
3 Instrument Setup and Status
command: :SYSTem:COMMunicate:ETHernet:DGATeway:CURRent?
syntax: :SYSTem:COMMunicate:ETHernet:DGATeway:CURRent?
description: Get the currently used default gateway.
parameters: none
response: string (maximum 79 characters)
example: :syst:comm:eth:dgat:curr? -> “192.168.101.11“<END>
command: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle
syntax: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle
description: Enable or disable DHCP
parameters: boolean (0 | 1 | off | on)
response: none
example: :syst:comm:eth:dhcp:enab on
command: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle?
syntax: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle?
description: Check whether DHCP is enabled or disabled.
parameters: none
response: boolean (0 | 1)
example: :syst:comm:eth:dhcp:enab?
-> 1<END>