78 8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
3 Instrument Setup and Status
command: :SYSTem:COMMunicate:ETHernet:DGATeway?
syntax: SYSTem:COMMunicate:ETHernet:DGATeway?
description: Get the default gateway.
parameters: none
response: string
example: :syst:comm:eth:dgat? -> “192.168.101.11“<END>
command: :SYSTem:COMMunicate:ETHernet:RESTart
syntax: :SYSTem:COMMunicate:ETHernet:RESTart
description: Restart the system’s network interface with the new parameters.
This command only works if the instrument has a working network connection at the time the command is issued.
If not you either have to wait until the instrument decides on an IP address using AutoIP or reboot the instrument.
parameters: none
response: string
example: :syst:comm:eth:rest
To Next Page
Loading...
