Keysight Technologies E364xA Series - Page 19

Keysight E364xA User’s and Service Guide 19
List of Figures
Figure 1-1 Rear output terminals . . . . . . . . . . . . . . . . . . . . . . . . .29
Figure 1-2 Line voltage selector (set for 115 Vac) . . . . . . . . . . . .36
Figure 1-3 Front panel outlook . . . . . . . . . . . . . . . . . . . . . . . . . . .42
Figure 1-4 Voltage and current limit settings . . . . . . . . . . . . . . . .44
Figure 1-5 Rear panel outlook . . . . . . . . . . . . . . . . . . . . . . . . . . . .45
Figure 1-6 Display annunciators . . . . . . . . . . . . . . . . . . . . . . . . . .46
Figure 1-7 Remote voltage sensing connections . . . . . . . . . . . . .51
Figure 1-8 Local sensing connections . . . . . . . . . . . . . . . . . . . . . .51
Figure 2-1 Recommended protection circuit for battery charging . .
70
Figure 2-2 Recommended connection to prevent voltage overshoot
71
Figure 2-3 DB-9 serial connection . . . . . . . . . . . . . . . . . . . . . . . .80
Figure 2-4 DB-25 serial connection . . . . . . . . . . . . . . . . . . . . . . .81
Figure 3-1 SCPI status system . . . . . . . . . . . . . . . . . . . . . . . . . . .127
Figure 6-1 Diagram of a simple series power supply . . . . . . . . .172
Figure 6-2 Block diagram of the power supply showing the remote in-
terface isolation . . . . . . . . . . . . . . . . . . . . . . . . . . .173
Figure 6-3 Ideal constant voltage
power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . .174
Figure 6-4 Ideal constant current power supply . . . . . . . . . . . . .174
Figure 6-5 Output characteristics . . . . . . . . . . . . . . . . . . . . . . . .175
Figure 6-6 Simplified diagram of common mode and normal mode
sources of noise . . . . . . . . . . . . . . . . . . . . . . . . . . .177
Figure 6-7 Speed of response - programming up (full load) . . .179
Figure 6-8 Speed of response - programming down . . . . . . . . .180
Figure 7-1 E364xA dimensions . . . . . . . . . . . . . . . . . . . . . . . . . .182
Figure 7-2 E364xA dimensions for rack mounting . . . . . . . . . . .183
Figure 8-1 Performance verification test setup . . . . . . . . . . . . . .203
Figure 8-2 Front/ rear panel terminal connections . . . . . . . . . . .204
Figure 8-3 Front/rear panel terminal connections for the Vrms
measurement . . . . . . . . . . . . . . . . . . . . . . . . . . . . .210
Figure 8-4 Transient response time . . . . . . . . . . . . . . . . . . . . . . .212
Figure 8-5 CC PARD (ripple and noise) connections . . . . . . . . .217