Keysight Technologies E4360 Series - Page 25

Performance Verification 2
Series E4360 Service Guide 25
Test Record Form – Keysight E4362A and E4362A-J51
Keysight Model E4362A & E4362A-J51 Report No _______________ Date __________________
Description Minimum Specs. Results Maximum Specs.
Constant Voltage Tests
Voltage Programming & Readback
Min. Voltage Vout
Voltage measured over interface
High Voltage Vout
Voltage measured over interface
− 50 mV
Vout − 50 mV
119.86 V
Vout − 146 mV
__________
__________
__________
__________
+ 50 mV
Vout + 50 mV
120.14 V
Vout + 146 mV
CV Load Effect
− 2 mV
__________ + 2 mV
CV Source Effect
− 2 mV
__________ + 2 mV
CV Ripple and Noise (at full and no load)
peak-to-peak (Fixed mode)
rms (Fixed mode)
peak-to-peak (SAS & Table mode)
rms (SAS & Table mode)
N/A
N/A
N/A
N/A
__________
__________
__________
__________
+ 150 mV
+ 30 mV
+ 195 mV
+ 24 mV
Constant Current Tests
Current Programming & Readback
Min. Current Iout
Current measured over interface
High Current Iout
Current measured over interface
−Current measured over interface
− 10 mA
Iout − 10 mA
4.98 A
Iout − 20 mA
Iout − 26 mA
__________
__________
__________
__________
__________
+ 10 mA
Iout + 10 mA
5.02 A
Iout + 20 mA
Iout + 26 mA
CC Load Effect
− 1 mA
__________ + 1 mA
CC Source Effect
− 1 mA
__________ + 1 mA
Test Description E4362A & E4362A-J51 Setting
Voltage Programming & Readback, Min 0 mV, 5.1 A
Voltage Programming & Readback, High 120 V, 5.1 A
CV Load Effect, Source Effect, Ripple and Noise 120 V, 5.1 A; Rload for ripple & noise = 24 Ω
Current Programming & Readback, Min 0 mA, 123 V
Current Programming & Readback, High 5 A, 123 V
CC Load Effect, Source Effect 5 A, 123 V
SAS Curve settings for Ripple and Noise tests Isc = 5; Imp = 5; Vmp = 120; Voc = 130