Keysight FieldFox Handheld Analyzers Service Guide 113
Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
2. To replace the entire kickstand assembly:
a. Lift the kickstand assembly off of the rear case and discard it.
b. Place the new kickstand assembly on the rear case.
c. Place the new hinge cover in position and secure it with four new
screws. A new hinge cover and new screws are provided in the
Repair and Re-assembly Kit.
3. To replace the hinge cover:
a. Position the new hinge cover in place and install four new screws.
New screws are provided in the Repair and Re-assembly Kit.
To Next Page
Loading...
Need help?
General
