190 Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide
Programming the Status Register System
Status Groups
Data Questionable Power Status Group
The Data Questionable Power Status Group is used to determine the specific
event that set bit 3 in the Data Questionable Condition Register. This group
consists of the Data Questionable Power Condition Register, the Data
Questionable Power Transition Filters (negative and positive), the Data
Questionable Power Event Register, and the Data Questionable Power Event
Enable Register.
Some of the bits in this status group do not apply to all models, and return
zero when queried. See Table 4-5 on page 191 for more information.
NOTE:
Some signal
generator
models may
use only a
subset of
the status
registers
shown.
To Next Page
Loading...
Need help?
General
