Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide 43
Using IO Interfaces
Using LAN
Setting Up the LAN Interface
For LAN operation, the signal generator must be connected to the LAN, and an
IP address must be assigned to the signal generator either manually or by
using DHCP client service. Your system administrator can tell you which
method to use. (Most modern LAN networks use DHCP.)
Configuring the VXI–11 Service
To communicate with the signal generator over the LAN, you must enable the
VXI–11 SCPI service. Select VXI–11 until On is highlighted. (Default condition
is On.)
Verify that the signal generator is connected to the LAN using a 100Base–
T LAN or 10Base–T LAN cable.
NOTE
For optimum performance, use a 100Base–T LAN cable to connect the signal generator to the LAN.
For details on each key or for a list of equivalent SCPI commands, use the front-panel key help. For information describing the
key help, refer to “Getting Key Help” on page 30 and the User’s Guide. For additional SCPI command information, refer to the
SCPI Command Reference.
Utility > IO Config
To Next Page
Loading...
Need help?
General
