319
Keysight Technologies
X-Series Signal Generators
Programming Guide
6 Creating and Downloading User–Data Files
This chapter explains the requirements and processes for creating and
downloading user data, and contains the following sections:
— User File Data (Bit/Binary) Downloads on page 327
— Pattern RAM (PRAM) Data Downloads on page 346
— FIR Filter Coefficient Downloads on page 360
— Using the Equalization Filter on page 364
— Save and Recall Instrument State Files on page 365
— User Flatness Correction Downloads Using C++ and VISA on page 379
— Data Transfer Troubleshooting on page 384
The following sections and procedures contain remote SCPI commands.
For front panel key commands, refer to the Key Help in the signal
generator.
To Next Page
Loading...
