Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide 73
Programming Examples
GPIB Programming Interface Examples
100 !
110 ! CLEAR and RESET the controller and type in the following
commands and then
120 ! RUN the program:
130 !
140
!******************************************************************
150 !
160 Sig_gen=719 ! Declares a variable to hold the signal
generator's address
170 LOCAL Sig_gen ! Places the signal generator into Local mode
180 CLEAR Sig_gen ! Clears any pending data I/O and resets the
parser
190 REMOTE 719 ! Puts the signal generator into remote mode
200 CLEAR SCREEN ! Clears the controllers display
210 REMOTE 719
220 OUTPUT Sig_gen;"*RST" ! Places the signal generator into a
defined state
230 PRINT "The signal generator should now be in REMOTE."
240 PRINT
250 PRINT "Verify that the remote [R] annunciator is on. Press the
`Local' key, "
260 PRINT "on the front panel to return the signal generator to
local control."
270 PRINT
280 PRINT "Press RUN to start again."
290 END ! Program ends
Interface Check Using NI-488.2 and C++
This example uses the NI-488.2 library to verify that the GPIB connections and
interface are functional. Launch Microsoft Visual C++ 6.0, add the required
files, and enter the following code into your .cpp source file.
The following program example is available on the signal generator
Documentation CD-ROM as niex1.cpp.
//
*******************************************************************
//
// PROGRAM NAME: niex1.cpp
To Next Page
Loading...
Need help?
General
