28 Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide
Getting Started with Remote Operation
Using the Web Browser
LAN Configuration System Defaults
If the instrument has been restored to the factory defaults from the LAN Setup
menu the signal generator will revert to the values displayed in
Table on page 28.
Refer to “Displaying the LAN Configuration Summary” on page 29.
To reset the instrument LXI password to “agilent” and the LAN settings to their
factory default values, press the following key sequence on the signal
generator:
Utility > I/O Config > LAN Setup > Advanced Settings > More 2 of 2 >
Restore LAN Settings to Default Values > Confirm Restore LAN Settings to
Default Values
For more information, refer to the signal generator’s Web Server Interface
Help.
The instrument’s LAN configuration system information can be found on
the signal generator’s homepage and on the signal generator. Refer to
“Enabling the Signal Generator Web Server” on page 26 and to “Displaying
the LAN Configuration Summary” on page 29.
There are no SCPI commands associated with this LXI password factory
reset.
Table 1-3 LAN Configuration Summary Values
Parameter Default
Signal Generator LAN Configuration Summary
Hostname: Keysight–<model number>–<last_5_chars_of_serial_number>
Config Type: AUTO
IP Address: 127.0.0.1
Connection
Monitoring:
On
Subnet: 255.255.255.0
DNS Server Override: Off
Gateway: 0.0.0.0
Dynamic DNS Naming: On
RFC NETBIOS Naming: On
DNS Server: 0.0.0.0
TCP Keep Alive: On
To Next Page
Loading...
Need help?
General
