Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide 201
Programming the Status Register System
Status Groups
Data Questionable BERT Event Register
The Data Questionable BERT Event Register latches transition events from the
condition register as specified by the transition filters. Event registers are
destructive read-only. Reading data from an event register clears the content
of that register.
Data Questionable BERT Event Enable Register
The Data Questionable BERT Event Enable Register lets you choose which bits
in the Data Questionable BERT Event Register set the summary bit (bit 3 of the
Data Questionable Condition Register) to 1.
Query: STATus:QUEStionable:BERT[:EVENt]?
Command: STATus:QUEStionable:BERT:ENABle <value> where <value> is the sum of the
decimal values of the bits you want to enable
Example: Enable bit 2 and bit 1 so that whenever either of those bits are set to 1, the Data Questionable BERT
summary bit of the Data Questionable Condition Register is set to 1. Send the command
STAT:QUES:BERT:ENAB 6 (4 + 2).
Query: STATus:QUEStionable:BERT:ENABle?
Response: Decimal value of the sum of the bits previously enabled with the
STATus:QUEStionable:BERT:ENABle <value> command.
To Next Page
Loading...
Need help?
General
