Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide 79
Programming Examples
GPIB Programming Interface Examples
#include "stdafx.h"
#include <iostream>
#include "windows.h"
#include "Decl-32.h"
using namespace std;
int GPIB0= 0; // Board handle
Addr4882_t Address[31]; // Declares a variable of
type Addr4882_t
int main()
{
int sig; // Declares variable to hold
interface descriptor
sig = ibdev(0, 19, 0, 13, 1, 0); // Opens and initialize a
device descriptor
ibclr(sig); // Sends GPIB Selected Device
Clear (SDC) message
ibwrt(sig, "*RST", 4); // Places signal generator
in a defined state
cout << "The signal generator should now be in REMOTE. The
remote mode R "<<endl;
cout <<"annunciator should appear on the signal generator
display."<<endl;
cout <<"Press Enter to continue"<<endl;
cin.ignore(10000,'\n');
SendIFC(GPIB0); // Resets the GPIB interface
Address[0]=19; // Signal generator's address
Address[1]=NOADDR; // Signifies end element in
array. Defined in //
DECL-32.H
SetRWLS(GPIB0, Address); // Places device in Remote
with Lockout State.
cout<< "The signal generator should now be in LOCAL LOCKOUT.
Verify that all keys"<<endl;
cout<< "including the 'Local' key are disabled (Contrast keys
are not affected)"<<endl;
To Next Page
Loading...
Need help?
General
