Installation Note N9030-90077 29
Option BBA, Analog Baseband I/Q Inputs Upgrade Kit
Final Installation
1. Refer to Figure 1. Carefully slide the instrument cover back onto the instrument from the rear
of the analyzer, making sure not to damage any internal cables. The seam on the cover should
be on the bottom of the instrument. Be sure the cover seats into the gasket groove in the Front
Frame Assembly.
2. Replace the four rear feet (4) to the rear of the instrument using the four screws (3). Torque
to 21 inch pounds.
3. Replace the strap handles (2) on both sides of the instrument using the four screws (1).
Torque to 21 inch pounds.
4. Replace the four instrument bottom feet.
5. Replace the four key locks to the bottom feet.
Install Instrument Software
http://www.keysight.com/find/pxa_software
This will guarantee:
— The analyzer has the latest instrument software version to support Option BBA.
— FPGA updates are done to the BBIQ hardware.
— The drivers are installed for the new hardware.
Licensing the Option
Installation Procedure over USB
1. Locate the Option Upgrade Entitlement Certificate (5964-5178) from the kit.
2. Redeem the Option Upgrade Entitlement Certificate by following the instructions on the
Certificate.
3. After redeeming your Option Upgrade Entitlement Certificate you will receive an email with an
attached License File.
4. Locate a USB storage device. Perform a virus scan on this device before use.
5. Save the License File to the root directory of the USB storage device.
6. Connect the USB storage device to one of the PXA USB ports. Windows will detect the new
hardware and may display the configuration menu shown in Figure 21. This menu may be
configured according to your preferences.
To Next Page
Loading...
Need help?
General
