Keysight 33210A - Page 154

152
Chapter 4 Remote Interface Reference
SCPI Command Summary
4
Command Summary
(see page 205 for more information)
FREQuency
:STARt {<
frequency>|MINimum|MAXimum}
:STARt? [MINimum|MAXimum]
:STOP {<
frequency>|MINimum|MAXimum}
:STOP? [MINimum|MAXimum]
FREQuency
:CENTer {<
frequency>|MINimum|MAXimum}
:CENTer? [MINimum|MAXimum]
:SPAN {<
frequency>|MINimum|MAXimum}
:SPAN? [MINimum|MAXimum]
SWEep
:SPACing {LINear|LOGarithmic}
:SPACing?
:TIME {<
seconds>|MINimum|MAXimum}
:TIME? [MINimum|MAXimum]
SWEep:STATe {OFF|ON}
SWEep:STATe?
TRIGger:SOURce {IMMediate|EXTernal|BUS}
TRIGger:SOURce?
TRIGger:SLOPe {POSitive|NEGative} “Trig In” Connector
TRIGger:SLOPe?
OUTPut
:TRIGger:SLOPe {POSitive|NEGative} “Trig Out” Connector
:TRIGger:SLOPe?
:TRIGger {OFF|ON}
:TRIGger?
MARKer:FREQuency {<
frequency>|MINimum|MAXimum}
MARKER:FREQuency? [MINimum|MAXimum]
MARKer {OFF|ON}
MARKer?
Sweep Commands
Parameters shown in bold are selected following a *RST (reset) command.
33210A users guide.book Page 152 Wednesday, July 16, 2008 11:16 AM