Keysight 33210A - Page 289

287
Chapter 5 Error Messages
Execution Errors
4
5
-222 Data out of range;
pulse edge time limited by duty cycle; value clipped to ...
The specified edge time must fit within the specified pulse duty cycle as
shown below. The function generator will adjust the edge time as needed
to accommodate the specified pulse duty cycle.
Edge Time <
0.625 X Period X Duty Cycle ÷ 100
-222 Data out of range;
period; value clipped to ...
This generic message indicates that the pulse period has been limited to
an upper or lower boundary.
-222 Data out of range;
frequency; value clipped to ...
This generic message indicates that the waveform frequency has been
limited to an upper or lower boundary.
-222 Data out of range;
user frequency; value clipped to upper limit
This generic message indicates that the waveform frequency has been
limited to an upper boundary due to the selection of the arbitrary
waveform function (APPL:USER or FUNC:USER command).
-222 Data out of range;
ramp frequency; value clipped to upper limit
This generic message indicates that the waveform frequency has been
limited to an upper boundary due to the selection of the ramp waveform
function (APPL:RAMP or FUNC:RAMP command).
-222 Data out of range;
pulse frequency; value clipped to upper limit
This generic message indicates that the waveform frequency has been
limited to an upper boundary due to the selection of the pulse waveform
function (APPL:PULS or FUNC:PULS command).
-222 Data out of range;
burst period; value clipped to ...
This generic message indicates that the burst period has been limited to
an upper or lower boundary.
33210A users guide.book Page 287 Wednesday, July 16, 2008 11:16 AM