Keysight 33210A - Page 290

288
Chapter 5 Error Messages
Execution Errors
5
-222 Data out of range;
burst count; value clipped to ...
This generic message indicates that the burst count has been limited to
an upper or lower boundary.
-222 Data out of range;
burst period limited by length of burst; value clipped to lower limit
It is not possible to specify a burst period which is too short for the
function generator to output with the specified burst count and
frequency (see below). If the burst period is too short, the function
generator will automatically adjust it as needed to continuously
re-trigger the burst.
Burst Period > + 200 ns
-222 Data out of range;
burst count limited by length of burst; value clipped to upper limit
If the Immediate trigger source is selected ( TRIG:SOUR IMM command ),
the burst count must be less than the product of the burst period and the
waveform frequency as shown below.
Burst Count < Burst Period X Waveform Frequency
-222 Data out of range;
amplitude; value clipped to ...
This generic message indicates that the waveform amplitude has been
limited to an upper or lower boundary.
-222 Data out of range;
offset; value clipped to ...
This generic message indicates that the offset voltage has been limited to
an upper or lower boundary.
-222 Data out of range;
frequency in burst mode; value clipped to ...
This generic message indicates that the frequency has been limited to an
upper or lower boundary as dictated by the burst period.
Burst Count
W
aveform Frequenc
y
-
------------------------------------------------------
----
33210A users guide.book Page 288 Wednesday, July 16, 2008 11:16 AM