9
4
Contents
Chapter 1 Specifications 11
Chapter 2 Quick Start 17
To Prepare the Function Generator for Use 19
To Adjust the Carrying Handle 20
To Set the Output Frequency 21
To Set the Output Amplitude 22
To Set a DC Offset Voltage 24
To Set the High-Level and Low-Level Values 25
To Select “DC Volts” 26
To Set the Duty Cycle of a Square Wave 27
To Configure a Pulse Waveform 28
To View a Waveform Graph 29
To Output a Stored Arbitrary Waveform 30
To Use the Built-In Help System 31
To Rack Mount the Function Generator 33
Chapter 3 Front-Panel Menu Operation 35
Front-Panel Menu Reference 37
To Select the Output Termination 39
To Reset the Function Generator 39
To Read the Calibration Information 40
To Unsecure and Secure for Calibration 41
To Store the Instrument State 44
To Configure the Remote Interface 45
Chapter 4 Calibration Procedures 51
Keysight Technologies Calibration Services 53
Calibration Interval 53
Adjustment is Recommended 53
Time Required for Calibration 54
Automating Calibration Procedures 55
Recommended Test Equipment 56
Test Considerations 57
Performance Verification Tests 58
Internal Timebase Verification 62
AC Amplitude (high-impedance) Verification 63
Low Frequency Flatness Verification 64
0 dB Range Flatness Verification 65
To Next Page
Loading...
