Keysight 33210A - Page 54

52
4
Calibration Procedures
This chapter contains procedures for verification of the instrument's
performance and adjustment (calibration). The chapter is divided into
the following sections:
•
Keysight Technologies Calibration Services, on page 53
• Calibration Interval, on page 53
• Adjustment is Recommended, on page 53
• Time Required for Calibration, on page 54
• Automating Calibration Procedures, on page 55
• Recommended Test Equipment, on page 56
• Test Considerations, on page 57
• Performance Verification Tests, on page 58
• Internal Timebase Verification, on page 62
• AC Amplitude (high-impedance) Verification, on page 63
• Low Frequency Flatness Verification, on page 64
• 0 dB Range Flatness Verification, on page 65
• +10 dB Range Flatness Verification, on page 67
• +20 dB Range Flatness Verification, on page 69
• Calibration Security, on page 71
• Calibration Message, on page 73
• Calibration Count, on page 73
• General Calibration/Adjustment Procedure, on page 74
• Aborting a Calibration in Progress, on page 75
• Sequence of Adjustments, on page 75
• Self-Test, on page 76
• Frequency (Internal Timebase) Adjustment, on page 77
• Internal ADC Adjustment/Self Calibration, on page 78
• Output Impedance Adjustment, on page 79
• AC Amplitude (high-impedance) Adjustment, on page 81
• Low Frequency Flatness Adjustment, on page 84
• 0 dB Range Flatness Adjustments, on page 85
• +10 dB Range Flatness Adjustments, on page 87
• +20 dB Range Flatness Adjustment, on page 89
• Calibration Errors, on page 92