Keysight 33210A - Calibration Error Codes

To Next Page

To Previous Page

Chapter 4 Calibration Procedures

+20 dB Range Flatness Adjustment

* Constants are stored after completing this setup.

Nominal Signal

Setup Frequency Amplitude

63* 100 kHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

64* 200 kHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

65* 500 kHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

66* 1.5 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

67* 3.0 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

68* 4.0 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

69* 6.0 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

70* 8.0 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

71* 9.9 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Elliptical Filter

72* 200 kHz 2.8 Vrms 22 dBm Flatness for 20 dB, Linear Phase Filter

73* 500 kHz 2.8 Vrms 22 dBm Flatness for 20 dB, Linear Phase Filter

74* 1.5 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Linear Phase Filter

75* 3.0 MHz 2.8 Vrms 22 dBm Flatness for 20 dB, Linear Phase Filter

Other manuals for Keysight 33210A