TRIGger Subsystem
The TRIGger subsystem configures the triggering that controls measurement acquisition.
Recommendation: All triggered measurements should be made using an
appropriate fixed manual range. That is, turn autorange off
([SENSe:]<function>:RANGe:AUTO OFF) or set a fixed range using the
[SENSe:]<function>:RANGe, CONFigure, or MEASure command.
Command Summary
TRIGger:COUNt
TRIGger:DELay
TRIGger:DELay:AUTO
TRIGger:LEVel
TRIGger:SLOPe
TRIGger:SOURce
Keysight Truevolt Series Operating and Service Guide
427
SCPI Programming Reference
To Next Page
Loading...
