1 Getting Started
44 Keysight 34980A Getting Started Guide
15 With the Channel key still lighted, turn the knob to display channel 1016. You
should see measurements start for DC VOLTS (your previously configured
function for channel 16).
16 With the Channel key still active, turn the knob between channels 1016 and
1014 to monitor the measurement results for each channel. As you pass
Channel 1015, which is not configured for a measurement, notice that the
associated channel relay is open and measurement is off.
17 Press the Channel key so the light is off. Notice that Monitoring is now turned
off, but you can continue to view the measurement parameters on channels
1014 and 1016.
In This Example:
– You configured channel 16 for dc voltage measurements.
– With the Channel key (in Measure key group), you started, viewed results, and
stopped continuous dc voltage measurements on channel 16.
– You configured channel 14 for ac voltage measurements.
– With the Channel key (in Measure key group), you started, viewed results, and
stopped continuous ac voltage measurements on channel 14.
To Next Page
Loading...
