Getting Started 1
Keysight 34980A Getting Started Guide 43
11 To stop the continuous measurements, press the Channel key again. Note that
as you press the Channel key, you will hear the relays automatically opening.
12 Using steps 1 through 6 on the previous page, set the following configuration
for Channel 1014. For this example, don't change any other measurement
parameters.
– Channel 1014
– AC VOLTS function
– 1V range
13 Press the EXIT MENU key to accept the new settings and retain all other
parameters in this menu.
14 With Channel 1014 selected, press the Channel key in the Measure key group.
The Channel key lights, the required relays automatically close, and
measurements begin.
To Next Page
Loading...
