Network Analyzer 7
Safety Notice Supplement
• This equipment complies with EN/IEC61010-1:2001.
• This equipment is of MEASUREMENT CATEGORY I (CAT
I). Do not use for CAT II, III, or IV.
• Do not connect the measuring terminals to mains.
• This equipment is a POLLUTION DEGREE 2, INDOOR
USE product.
• This equipment is tested in stand-alone condition and in
combination with the accessories supplied by Keysight
Technologies against the requirement of the standards
described in the Declaration of Conformity. If it is used
as a system component, compliance of related regulations
and safety requirements are to be confirmed by the
builder of the system.
To Next Page
Loading...
