Utility Settings 22
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide 239
The resultant string is displayed in the "Text =" line.
3 Press the Wait softkey; then, turn the Entry knob to select the
number of minutes to wait before the selected screen saver
activates.
When you turn the Entry knob, the number of minutes is
displayed on the Wait softkey. The default time is 180
minutes (3 hours).
4 Press the Preview softkey to preview the screen saver you
have selected with the Saver softkey.
5 To view the normal display after the screen saver has started,
press any key or turn any knob.
To set Autoscale preferences
1 Press [Utility] > Options > Preferences > Autoscale.
2 In the Autoscale Pref menu, you can:
• Press the Fast Debug softkey enable/disable this type of autoscale.
When fast debug is enabled, autoscale lets you make quick visual
comparisons to determine whether the signal being probed is a DC voltage,
ground, or an active AC signal.
Channel coupling is maintained to allow easy viewing of oscillating signals.
• Press the Channels softkey and turn the Entry knob to specify the channels to
be autoscaled:
• All Channels — The next time you press [Auto Scale], all channels that meet
the requirements of Autoscale will be displayed.
• Only Displayed Channels — The next time you press [Auto Scale], only the
channels that are turned on will be examined for signal activity. This is
useful if you only want to view specific active channels after pressing
[Auto Scale].
• Press the Acq Mode softkey and turn the Entry knob to select whether the
acquisition mode should be preserved during autoscale:
To Next Page
Loading...
