Need help?Do you have a question about the Keysight EDUX1052A and is the answer not in the manual?
General| Bandwidth | 50 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1 GSa/s |
| Memory Depth | 1 Mpts |
| Display Size | 7 inch |
| Display Type | TFT LCD |
| Display Resolution | 800 x 480 pixels |
| Vertical Sensitivity | 2 mV/div to 10 V/div |
| Vertical Resolution | 8 bits |
| Probe Interface | BNC |
| Operating Temperature | 0 °C to 50 °C |
| Record Length | 1 Mpts |
| Trigger Types | Edge, Pulse, Video |
| Waveform Capture Rate | 50, 000 wfm/s |
| Timebase Accuracy | 50 ppm |
Covers initial setup, basic operation, and learning the oscilloscope's controls and display.
Explains how to adjust time base, position, and zoom settings for waveform analysis.
Details how to set vertical scale, position, coupling, and other channel parameters.
Information on setting up trigger conditions to capture specific events in waveforms.
How to perform automatic measurements on waveforms, including voltage, time, and counts.
Setup and usage of CAN bus triggering and serial data decoding features.
Setup and usage of I2C bus triggering and serial data decoding features.
Setup and usage of SPI bus triggering and serial data decoding features.
Setup and usage of UART/RS232 bus triggering and serial data decoding features.
Adjusting the horizontal scale (sweep speed) to set the time/div setting for waveform viewing.
Adjusting the vertical scale knob to change vertical sensitivity (gain) for analog channels.
Adjusting the vertical level for analog channel edge detection using the trigger level knob.
Triggering based on a specified edge (slope) and voltage level on a waveform.
Triggering on positive or negative pulses of a specified width.
Using the [Meas] key to display automatic measurement options and make measurements.
Measuring voltage-related parameters like peak-peak, maximum, minimum, and amplitude.
Measuring time-related parameters like period, frequency, rise time, and fall time.
To Next Page
