Keysight EDUX1052A - 25 CAN Triggering and Serial Decode; Setup for CAN Signals

275
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes
User's Guide
25 CAN Triggering and Serial
Decode
Setup for CAN Signals / 275
CAN Triggering / 277
CAN Serial Decode / 279
CAN triggering and serial decode is available on DSOX1200-Series oscilloscopes.
Setup for CAN Signals
Setup consists of connecting the oscilloscope to a CAN signal, using the CAN
Signals menu to specify the signal source, threshold voltage level, baud rate, and
sample point.
To set up the oscilloscope to capture CAN signals, use the Signals softkey which
appears in the Analyze menu:
1 Press [Display] > Labels > Display to turn on labels.
2 Press the [Analyze] key.
3 Press Features; then, select Serial Bus.
4 Press Features again (or push the Entry knob) to enable the serial bus display.
5 Press the Mode softkey; then, select CAN.