Keysight EDUX1052A - To Recall Setup Files; To Recall Mask Files

Save/Recall (Setups, Screens, Data) 20
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide 223
3 In the Recall menu, press Recall:, then, turn the Entry knob to select the type of
file you want to recall:
• Setup (*.scp) — See "To recall setup files" on page 223.
• Mask (*.msk) — See "To recall mask files" on page 223.
• Reference Waveform data (*.h5) — See "To recall reference waveform files from
a USB storage device" on page 224.
You can also recall setups and mask files by loading them using the File Explorer.
See "File Explorer" on page 234.
You can also configure the [Quick Action] key to recall setups, masks, or reference
waveforms. See "Configuring the [Quick Action] Key" on page 246.
To recall setup files
Setup files can be recalled from one of 10 internal (/User Files) locations or from
an external USB storage device.
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select Setup
(*.scp).
2 Press the softkey in the second position and use the Entry knob to navigate to
the file to recall. See "To navigate storage locations" on page 221.
3 Press the Press to Recall softkey.
A message indicating whether the recall was successful is displayed.
4 If you would like to clear the display, press Clear Display.
To recall mask files
Mask files can be recalled from one of four internal (/User Files) locations or from
an external USB storage device.
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select Mask
(*.msk).
2 Press the softkey in the second position and use the Entry knob to navigate to
the file to recall. See "To navigate storage locations" on page 221.
3 Press the Press to Recall softkey.
A message indicating whether the recall was successful is displayed.
4 If you would like to clear the display or clear the recalled mask, press Clear
Display or Clear Mask.