Need help?Do you have a question about the Keysight DSOX3104T and is the answer not in the manual?
General| Bandwidth | 1 GHz |
|---|---|
| Channels | 4 |
| Form Factor | Benchtop |
| Waveform Update Rate | 1, 000, 000 waveforms/sec |
| Vertical Resolution | 8 bits |
| Input Coupling | AC, DC, GND |
| Connectivity | USB, LAN |
| Input Impedance | 1 MΩ |
| Maximum Input Voltage | 400 V (DC + AC peak) |
| Trigger Types | Edge, Pulse Width, Pattern, Sequence |
| Operating Temperature | 0 °C to 50 °C |
| Sample Rate | 5 GSa/s (half channel), 2.5 GSa/s (all channels) |
| Memory Depth | 4 Mpts (half channel), 2 Mpts (all channels) |
Connect the power cord, press the power switch, and wait for the self-test.
Connect the probe to the channel BNC connector and the retractable hook tip to the test point.
Match probe input capacitance to oscilloscope channel for accurate measurements.
Adjust time per division using the horizontal scale knob to set sweep speed.
Move the trigger point horizontally using the delay knob.
Set vertical sensitivity (volts/division) using the large knob above the channel key.
Adjust the vertical level for analog channel edge detection using the Trigger Level knob.
Define trigger by specified edge slope and voltage level on a waveform.
Use the [Meas] key to display the Measurement Menu and add measurements.
Measure voltage parameters like Peak-Peak, Maximum, Minimum, Amplitude, and Top.
Measure Period, Frequency, Pulse Width, Duty Cycle, Rise Time, and Fall Time.
Save oscilloscope setups, screen images, or waveform data to internal memory or USB.
To Next Page