Need help?Do you have a question about the Keysight DSOX1202A and is the answer not in the manual?
General| Brand | Keysight |
|---|---|
| Model | DSOX1202A |
| Category | Test Equipment |
| Language | English |
Defines CAUTION and WARNING notices for hazards and safety.
Provides instructions for connecting power and turning on the oscilloscope.
Explains how to connect oscilloscope probes to the instrument and test points.
Describes how to change the horizontal scale (sweep speed) to adjust time/div.
Explains how to use the horizontal position knob to pan waveform data horizontally.
Explains how to use the vertical scale knob to set vertical sensitivity (gain).
Explains how to set up edge triggers based on slope and voltage level.
Describes how to trigger on positive or negative pulses of a specified width.
Explains the difference between Auto and Normal trigger modes and how to select them.
Guides on using horizontal and vertical cursors for custom measurements on waveforms.
Explains how to use the [Meas] key to perform automatic measurements on waveforms.
Covers saving oscilloscope setups, screen images, and waveform data to internal memory or USB.
Provides instructions for printing the complete oscilloscope display to a USB or network printer.
Details accessing the Browser Web Control page for Remote Front Panel and SCPI commands.
Describes how to trigger on I2C signals for stop/start conditions, restarts, and specific data values.
Explains how to trigger on LIN signals based on Sync Break, Frame ID, or ID and Data.
Explains how to trigger on SPI signals based on data patterns at the start of a frame.
Explains how to trigger on UART/RS232 signals based on Rx start/stop bits or data values.
To Next Page