280 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
25 CAN Triggering and Serial Decode
See Also • "Interpreting CAN Decode" on page 280
• "CAN Totalizer" on page 281
• "Interpreting CAN Lister Data" on page 282
Interpreting CAN Decode
• Frame ID appears in hex digits in yellow. Frames of 11 or 29 bits are
automatically detected.
• Remote frame (RMT) appears in green.
• Data length code (DLC) appears in blue for data frames and green for remote
frames.
• Data bytes appear in hex digits in white for data frames.
• Cyclic redundancy check (CRC) appears in hex digits in blue when valid, or in
red to indicate that the oscilloscope's hardware decode calculated a CRC that
is different from the incoming CRC data stream.
• Angled waveforms show an active bus (inside a packet/frame).
• Mid-level blue lines show an idle bus.
• Decoded text is truncated at the end of the associated frame when there is
insufficient space within frame boundaries.
To Next Page
Loading...
