236 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
22 Utility Settings
• Eject — press this softkey to properly unmount a USB storage device before
removal.
If you remove the device without pressing the Eject softkey first, the device
will be marked as needing repair when connecting to a computer with the
Windows operating system (even though there are no harmful effects to the
device).
USB Storage
Devices
Use your PC to create directories on a USB storage device.
Most USB mass storage devices are compatible with the oscilloscope. However,
certain devices may be incompatible, and may not be able to be read or written to.
USB storage devices must be formatted with the FAT/FAT16, FAT32, NTFS, EXT2,
EXT3, or EXT4 file system format. The exFAT format is not supported. Any given
storage device may not support all of these formats.
When the USB mass storage device is connected to the oscilloscope's USB host
port, a small four-color circle icon may be displayed briefly as the USB storage
device is read.
You must "eject" a USB mass storage device before unplugging it; otherwise, the
device will be marked as needing repair when connecting to a computer with the
Windows operating system (even though there are no harmful effects to the
device).
Do not connect USB storage devices that identify themselves as hardware type
"CD" because these devices are not compatible with the InfiniiVision X-Series
oscilloscopes.
See Also • Chapter 20, “Save/Recall (Setups, Screens, Data),” starting on page 215
Setting Oscilloscope Preferences
The User Preferences menu (under [Utility] > Options > Preferences) lets you specify
oscilloscope preferences.
• "To choose "expand about" center or ground" on page 237
• "To disable/enable transparent backgrounds" on page 237
• "To load the default label library" on page 237
• "To set up the screen saver" on page 237
• "To set Autoscale preferences" on page 239
To Next Page
Loading...
