Keysight DSOX1202A - CAN Serial Decode

CAN Triggering and Serial Decode 25
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide 279
To display CAN serial decode, see "CAN Serial Decode" on page 279.
CAN Serial Decode
To set up the oscilloscope to capture CAN signals, see "Setup for CAN Signals" on
page 275.
For CAN triggering set up see "CAN Triggering" on page 277.
To set up CAN serial decode:
1 Press the [Analyze] key.
2 Press Features; then, select Serial Bus.
3 Press Features again (or push the Entry knob) to enable the serial bus display.
4 Press the Mode softkey; then, select CAN.
5 If the oscilloscope is stopped, press the [Run/Stop] key to
acquire and decode data.
You can use the horizontal Zoom window for easier navigation of the decoded data.
NOTE
If the setup does not produce a stable trigger, the CAN signal may be slow enough that the
oscilloscope is auto-triggering. Press the [Trigger] key, then press the Mode softkey to set the
trigger mode from Auto to Normal.