254 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
23 Web Interface
Remote Programming with Keysight IO Libraries
While the SCPI Commands applet window lets you enter and remote
programming commands, remote programming for automated test and data
acquisition is typically done using the Keysight IO Libraries, which are separate
from the instrument's web interface.
The Keysight IO Libraries let a controller PC communicate with Keysight
InfiniiVision X-Series oscilloscopes via their USB, LAN, or GPIB interfaces (if
available).
The Keysight IO Libraries Suite connectivity software to enables communication
over these interfaces. You can download the Keysight IO Libraries Suite from
www.keysight.com/find/iolib.
Information about controlling the oscilloscope through remote commands is
contained in the Programmer's Guide. You can access this document on the
Keysight web site.
For more information about connecting to the oscilloscope, refer to the Keysight
Technologies USB/LAN/GPIB Interfaces Connectivity Guide. For a printable
electronic copy of the Connectivity Guide, direct your Web browser to
www.keysight.com and search for "Connectivity Guide".
Get Image
To save (or print) the oscilloscope's display from the web interface:
1 Access the oscilloscope's web interface (see "Accessing the Web Interface" on
page 250).
2 When the oscilloscope's web interface is displayed, select the Get Image tab
from the left side of the Welcome screen. After a delay of several seconds, the
oscilloscope's screen image will be displayed.
3 Right-click on the image and select Save Picture As... (or Print Picture...).
4 Select a storage location for the image file and click Save.
To Next Page
Loading...
