264 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
24 Reference
Because the 1200 X-Series oscilloscopes do not have a ring around the BNC
connector for identifying probes, you must set the probe attenuation factor
manually. See "Setting Analog Channel Probe Options" on page 51.
See Also For more information on probes and accessories, see www.keysight.com for:
• Probes and Accessories Selection Guide (5989-6162EN)
• InfiniiVision Oscilloscope Probes and Accessories Selection Guide Data Sheet
(5968-8153EN)
• For compatibility information, manuals, application notes, data sheets,
selection guides, SPICE models, and more for oscilloscope probes, see the
Probe Resource Center at: www.keysight.com/find/PRC
Software and Firmware Updates
From time to time Keysight Technologies releases software and firmware updates
for its products. To search for firmware updates for your oscilloscope, direct your
web browser to www.keysight.com/find/1200X-Series-sw.
To view the currently installed software and firmware press [Help] > About
Oscilloscope.
Once you have downloaded a firmware update file, you can place it on a USB
storage device and load the file using File Explorer (see Chapter 22, “Utility
Settings,” starting on page 231).
Binary Data (.bin) Format
The binary data format stores waveform data in binary format and provides data
headers that describe that data.
Because the data is in binary format, the size of the file is approximately 5 times
smaller than the ASCII XY format.
If more than one source is on, all displayed sources will be saved, except math
functions.
To Next Page
Loading...
