Keysight DSOX1202A - Recalling Setups, Masks, or Reference Waveforms

222 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
20 Save/Recall (Setups, Screens, Data)
When saving files:
• The proposed file name is shown in the Save to file = line.
• To overwrite an existing file, browse to that file and select it. To create a new file
name, see "To enter file names" on page 222.
To enter file names
To create new file names when saving files to a USB storage device:
1 In the Save menu, press the File Name softkey.
You must have a USB storage device connected to the oscilloscope for this
softkey to be active.
2 In the File Name menu, use the Spell, Enter, and Delete Character softkeys to
enter the file name:
• Spell — press this softkey and turn the Entry knob to select the character at
the current position.
• Enter — press this softkey to enter characters and move the cursor to the next
character position. Pushing the Entry knob is the same as pressing the Enter
softkey.
• Delete Character — press this softkey to delete the character at the current
position.
When available, the Increment softkey can be used to enable or disable
automatically incremented file names. Auto increment adds a numeric suffix to
your file name and increments the number with each successive save. It will
truncate characters as necessary when the file name length is at maximum and
more digits are required for the numeric portion of the file name.
Recalling Setups, Masks, or Reference Waveforms
1 Press the [Save/Recall] key.
2 In the Save/Recall menu, press Recall.
NOTE
You can use a connected USB keyboard instead of using the Spell (and other) character
editing softkeys.