Keysight DSOX1202A - Setup for LIN Signals

293
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes
User's Guide
27 LIN Triggering and Serial
Decode
Setup for LIN Signals / 293
LIN Triggering / 295
LIN Serial Decode / 297
LIN triggering and serial decode is available on DSOX1200-Series oscilloscopes.
Setup for LIN Signals
LIN (Local Interconnect Network) signal setup consists of connecting the
oscilloscope to a serial LIN signal, specifying the signal source, threshold voltage
level, baud rate, sample point, and other LIN signal parameters.
To set up the oscilloscope to capture LIN signals:
1 Press [Display] > Labels > Display to turn on labels.
2 Press the [Analyze] key.
3 Press Features; then, select Serial Bus.
4 Press Features again (or push the Entry knob) to enable the serial bus display.
5 Press the Mode softkey; then, select LIN.