156 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
15 Measurements
To make automatic measurements
1 Press the [Meas] key to display the Measurement menu.
2 Press the Source softkey to select the channel, running math
function, or reference waveform to be measured.
Only channels, math functions, or reference waveforms that
are displayed are available for measurements.
If a portion of the waveform required for a measurement is
not displayed or does not display enough resolution to make
the measurement, the result will display "No Edges",
"Clipped", "Low Signal", "< value", or "> value", or a similar
message to indicate that the measurement may not be
reliable.
3 Press the Type softkey then rotate the Entry knob to select a
measurement to be made.
For more information on the types of measurements, see "Measurements
Summary" on page 157.
To Next Page
Loading...
