SPI Triggering and Serial Decode 28
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide 309
The Set all Bits softkey will set all bits in the data string to the value of the 0 1 X
softkey.
For SPI decode information see "SPI Serial Decode" on page 309.
SPI Serial Decode
To set up the oscilloscope to capture SPI signals, see "Setup for SPI Signals" on
page 301.
For SPI triggering setup see "SPI Triggering" on page 307.
To set up SPI serial decode:
1 Press the [Analyze] key.
2 Press Features; then, select Serial Bus.
3 Press Features again (or push the Entry knob) to enable the serial bus display.
To Next Page
Loading...
