Keysight DSOX1202A - To Save Lister Data Files; To Save Reference Waveform Files to a USB Storage Device

220 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
20 Save/Recall (Setups, Screens, Data)
See Also • "Binary Data (.bin) Format" on page 264
• "CSV and ASCII XY files" on page 271
• "Minimum and Maximum Values in CSV Files" on page 272
To save Lister data files
Lister data files can be saved to an external USB storage device.
1 Press [Save/Recall] > Save > Format; then, turn the Entry knob to select Lister data
(*.csv).
2 Press the softkey in the second position and use the Entry knob to navigate to
the save location. See "To navigate storage locations" on page 221.
3 Press the Settings softkey.
In the File Settings Menu, you have these softkeys and options:
• Setup Info — when enabled, setup information (vertical, horizontal, trigger,
acquisition, math, and display settings) is also saved in a separate file with a
TXT extension.
4 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
To save reference waveform files to a USB storage device
1 Press the [Save/Recall] key.
2 In the Save/Recall menu, press the Save softkey.
3 In the Save menu, press the Format softkey and turn the Entry knob to select
Reference Waveform data (*.h5) .
4 Press the Source softkey and turn the Entry knob to select the source waveform.
5 Press the softkey in the second position and use the Entry knob to navigate to
the save location. See "To navigate storage locations" on page 221.
Data File Format Save Times
BIN fastest
ASCII XY medium
CSV slowest