160 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
15 Measurements
Voltage Measurements
The following figure shows the voltage measurement points.
Measurement units for each input channel can be set to Volts or Amps using the
channel Probe Units softkey. See "To specify the channel units" on page 52.
The units of math waveforms are described in "Units for Math Waveforms" on
page 67.
• "Peak-Peak" on page 160
• "Maximum" on page 160
• "Minimum" on page 161
• "Amplitude" on page 161
• "Top" on page 161
• "Base" on page 162
• "Overshoot" on page 162
• "Preshoot" on page 163
• "Average" on page 164
• "DC RMS" on page 164
• "AC RMS" on page 165
Peak-Peak
The peak-to-peak value is the difference between Maximum and Minimum values.
The Y cursors show the values being measured.
Maximum
Maximum is the highest value in the waveform display. The Y cursor shows the
value being measured.
Amplitude
Maximum
Minimum
Base
Top
Peak-Peak
To Next Page
Loading...
