Keysight DSOX1202A - To Display a Reference Waveform

78 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
7 Reference Waveforms
5 In the Save/Clear menu, press the Source softkey and turn the Entry knob to
select the source waveform.
6 Press the Save to R1/R2 softkey to save the waveform to the reference waveform
location.
To clear a
reference
waveform location
1 Press the [Analyze] key.
2 Press Features; then, select R1 or R2.
3 Press Features again (or push the Entry knob) to turn on the reference waveform.
4 Press Save/Clear.
5 In the Save/Clear menu, press the Clear R1/R2 softkey to clear the reference
waveform location.
Reference waveforms are also cleared by a Factory Default or Secure Erase (see
Chapter 20, “Save/Recall (Setups, Screens, Data),” starting on page 215).
To display a reference waveform
1 Press the [Analyze] key.
2 Press Features; then, select R1 or R2.
3 Press Features again (or push the Entry knob) to turn on the reference waveform.
NOTE
Reference waveforms are non-volatile — they remain after power cycling or performing a
default setup.