Keysight DSOX1202A - To Save Masks; To Navigate Storage Locations

Save/Recall (Setups, Screens, Data) 20
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide 221
6 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
To save masks
Mask files can be saved to one of four internal (/User Files) locations or to an
external USB storage device.
1 Press [Save/Recall] > Save > Format; then, turn the Entry knob to select Mask
(*.msk).
2 Press the softkey in the second position and use the Entry knob to navigate to
the save location. See "To navigate storage locations" on page 221.
3 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
Mask files have the extension MSK.
See Also • Chapter 16, “Mask Testing,” starting on page 179
To navigate storage locations
When saving or recalling files, the softkey in the second position of the Save menu
or Recall menu, along with the Entry knob, are used to navigate to storage
locations. The storage locations can be internal oscilloscope storage locations (for
setup files or mask files) or they can be external storage locations on a connected
USB storage device.
The softkey in the second position can have these labels:
• Press to go — when you can push the Entry knob to navigate to a new folder or
storage location.
• Location — when you have navigated to the current folder location (and are not
saving files).
• Save to — when you can save to the selected location.
• Load from — when you can recall from the selected file.
NOTE
Masks are also saved as part of setup files. See "To save setup files" on page 217.