Keysight DSOX1202A - To Set up Frequency Modulation (FM)

210 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
19 Waveform Generator
4 Press the AM Depth softkey and turn the Entry knob to specify the amount of
amplitude modulation.
AM Depth refers to the portion of the amplitude range that will be used by the
modulation. For example, a depth setting of 80% causes the output amplitude
to vary from 10% to 90% (90% – 10% = 80%) of the original amplitude as the
modulating signal goes from its minimum to maximum amplitude.
The following screen shows an AM modulation of a 100 kHz sine wave carrier
signal.
To set up Frequency Modulation (FM)
In the Wave Gen Mod menu (under [Wave Gen] > Settings > Modulation):
1 Press the Type softkey and turn the Entry knob to select Frequency Modulation
(FM).
2 Press the Waveform softkey and turn the Entry knob to select the shape of the
modulating signal:
• Sine
• Square
• Ramp