28 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
1 Getting Started
Figure 4 InfiniiVision 1200 X-Series 2-Channel Oscilloscopes
Mixed Signal Oscilloscope
MSOX1204G
Digital Storage Oscilloscope
DSOX1202G
200 MHz 2 GSa/s70 MHz 2 GSa/s
InfiniiVision
Push
Fine
Push
Zero
Push to
Select
Force
Entry
Horizontal
Leve-l
Measure
Vertic al
Intensity
Push
for Fine
Push
to Zero
Trigger
Push for 50%
Push to Select
Tri g g e r
FFT
External
Math
Default
Setup
Run
Stop
Single
Wave
Gen
Acquire
2
1
CursorsMeas
Utility
Analyze
Display
Save
to USB
Help
Save
Recall
Auto
Scale
Back
Quick
Action
Demo
Probe
Comp
Ext
Tr i g
Gen
Out
Inputs
CH1 and CH2
150V RMS
Input
Ext Trig
30V RMS
~
1M
~
16pF
Demo
Probe
Comp
1
2
22. Ext Trig
external trigger
input
21. [External] key
1. Power switch Press once to switch power on; press again to switch power off. See "Power-On the
Oscilloscope" on page 22.
2. Softkeys The functions of these keys change based upon the menus shown on the display next to the keys.
The Back key moves back in the softkey menu hierarchy. At the top of the hierarchy, the
Back key turns the menus off, and oscilloscope information is shown instead.
3. [Intensity] key Press the key to illuminate it. When illuminated, turn the Entry knob to adjust waveform intensity.
You can vary the intensity control to bring out signal detail, much like an analog oscilloscope.
4. Entry knob The Entry knob is used to select items from menus and to change values. The function of the Entry
knob changes based upon the current menu and softkey selections.
Note that when the Entry knob symbol appears on a softkey, you can use the Entry knob, to
select values.
Often, rotating the Entry knob is enough to make a selection. Sometimes, you can push the Entry
knob to enable or disable a selection. Also, pushing the Entry knob can also make popup menus
disappear.
To Next Page
Loading...
